This is helpful to indicate that the user has fully pushed each button of the combination. When enabled, a beep is sounded each time a button is pushed. Switch #3 enables the Audio function when the switch is 'on'. When the switch is set 'on', the SmartCode will automatically lock and extend the bolt 30 seconds after the lock has been unlocked. Switch #2 controls an automatic locking feature. If switch #1 is set to the 'off' position, the LED will only flash to indicate a low battery situation. If the lock is in an unlocked position, the LED will flash green every five seconds. When set to the 'on' position, and with the lock in a locked position, an LED light will flash intermittently red and orange every three to five seconds. Switch #1 can set the indicator light on or off. Beneath the trim is a switch panel with four miniature switches. A slide-up cover is located on the inside trim. The deadbolt can either be optionally set to automatically relock after 30 seconds or the lock button can be pressed after the door is closed and the bolt will be moved by the electric motor into a locked position in the strike plate.Įlectronics can provide additional options and Kwikset SmartCode locks takes full advantage of the possibilities. As the last number of a correct code is pressed on the keypad, the electric motor swings into action and retracts the deadbolt. Locking and unlocking from the outside can be done automatically by an electric motor. Unlocking from the inside of the door is done manually by turning the thumb turn. Our sample is a deadbolt version which has a motor-driven deadbolt. Kwikset SmartCode locks are available as lever sets or deadbolt locks. The second code can be quickly changed as needed while the users of the primary existing code are not affected by any secondary code changes. This allows building residents to use their existing opening code while a second code can be issued to allow short-term users such as relatives or workmen to have access to the building. Two different code numbers can be programmed into the SmartCode lock. Owner-programmed code numbers can be from four (4) to eight (8) digits in length. Each of the numbered buttons contains two numbers such as '12', '34', '56', etc. Kwikset SmartCode keyless entry locks contain five numbered buttons and a sixth button which Kwikset describes as a "lock button". These Kwikset locks solve the lost or forgotten key question with a system which is easier and faster to use, compared to locating and inserting a mechanical key. " That is the message Kwikset is using to introduce the new SmartCode locksets. The convenience of keyless technology is now available at your fingertips.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |